Soluna Track

Initial Pairing and Reset Instructions (Wall Switch or Power-disconnection Reset)

After the light is connected to power, it will automatically enter Matter pairing mode and slowly flash white. You can then use a Matter-compatible mobile device to scan the QR code on the product and pair it.

If the light does not slowly flash white or pairing cannot be completed, restart pairing mode using the following method.

Reset with the Power Switch or by Disconnecting the Power Supply

• The track light has no physical switch. Use the wall power switch, or directly disconnect and reconnect the power supply, to perform 9 consecutive power-on and power-off cycles. Turning the power on and then off counts as one cycle.
• When the power is turned on for the first time, the light will flash once to indicate that reset timing has begun.
• The light will flash once in response each time the power is switched.
• Wait for each flash to finish before switching the power again.
• Resetting may fail if you switch too quickly or too slowly.

After the 9th cycle, the light will slowly flash white again and can be paired once more.

Installation Steps

Preparation

• Confirm that the package contains one Soluna Track unit.
• The power must be disconnected before installation to ensure safety.
• This product does not have a ground wire.

Check the Track and Specifications

• This product is compatible only with magnetic tracks. Contact customer service for compatibility details.

Connect the Power

• Product input voltage: DC 48V.
• Never connect a conventional wall-mounted rotary dimmer in series with the power circuit. Doing so may damage the equipment or prevent pairing.

Install the Track Light

• Magnetic mounting: Place the track light directly onto the magnetic track. It will attach and lock in place automatically without additional tools.

Power-on Test

• Restore power: After the power is turned on and pairing is complete, the light can be controlled through an app or voice assistant.

Important Notes

Electrical Safety

• Always disconnect the power before installation to prevent electric shock.
• This product does not have a ground wire.
• Make sure the input voltage matches the specification (DC 48V).

Installation Requirements

• Use only with a magnetic track system.
• Never connect a conventional wall-mounted rotary dimmer in series with the power circuit.

Environmental Conditions

• This product is not waterproof. Use in a dry environment is recommended. Avoid prolonged exposure to damp or high-temperature areas to extend its service life.
• Handle the product carefully during installation to prevent damage to the housing that could affect heat dissipation.

Dimming

• Supports Matter and is suitable for integration with smart home systems.
• The magnetic track light has an integrated design and no adjustable switch on the body. Use the control system to adjust brightness.

Care and Maintenance

• Regularly remove dust from the light's surface to maintain consistent light output.
• If you notice an abnormality, disconnect the power immediately and contact a qualified professional for inspection and repair.

Warranty Coverage

• This product's warranty covers the Soluna Track body.
• Product damage caused by use with an incompatible track or power device is not covered by the warranty.